Photo Gallery

---

 These drop in trays are custom built to fit models such as  the Minn Kota Terova foot pedal. They are only 1.5" deep to accommodate the thinner non wire driven foot pedals.  

Custom made drop in dry hatches. They can be built to fit any opening. They come standard with the rubber gasket, and can be customized with locking handles, pull handles,  and drain tubes.

This is an over the foot pedal custom mounting bracket. We offer these in customizable heights, widths, and logos cut in the sides.

Prices vary depending on size, and required equipment.

1" aluminum pipe to receive 3/4" or 7/8" anchor pole. These are sold as bolt on, or weldable, and with or without Transom strap hole.

Prices vary per design.

Preparing the transom to weld on the float pods.

90% of all our Aluminum Welding is done with TIG.

A tig welded vertical uphill aluminum weld on the side of the Float pods to insure penetration and give a clean smooth surface.

After installation the Pods are sanded and painted.

Float Pods are an excellent addition to any aluminum boat. They help stabilize the back of the boat, especially if you have a large motor like the one in this picture. They also keep the back end from sitting to low in the water which allows the boat to run in very shallow water.

Contact Professional Welding to get your custom Float Pods today